Skip to content
Serving Brooklyn and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (912) 881-8281

Chimney Repair in Brooklyn Heights, Brooklyn

Serving Brooklyn Heights and nearby cities.

Tell us what’s going on

Prefer to talk? (912) 881-8281

The short answer

EliteFlue repairs chimneys in Brooklyn Heights brownstones, rowhouses and pre-war buildings, including masonry, crowns, flashing, caps, dampers and flue liners. We start with an inspection to find the cause of the damage. Then we recommend the repair that fixes it, including relining when a building switches from oil to gas.

Brooklyn Heights is mostly brownstones, rowhouses and pre-war apartment buildings, and many of them still vent fireplaces and boilers through masonry chimneys that have been in service for generations. EliteFlue Chimney Services repairs these chimneys from our office in Fort Greene, about a mile southeast of the neighborhood. Our certified technicians first work out why a chimney is failing, whether from water, heat, age or a change in fuel. Then we repair the cause instead of patching the symptom. Below are the repairs we see most often in Brooklyn Heights homes and how a typical job goes.

Why Brooklyn Heights chimneys need repair

Older masonry chimneys in this part of Brooklyn tend to fail in predictable ways. Rooftop stacks sit fully exposed to rain, wind and winter freeze-thaw cycles. Water that gets into mortar joints expands when it freezes and slowly pushes the masonry apart. Inside, decades of heat and combustion byproducts wear down clay tile liners and the mortar between them.

In attached rowhouses, the problem is often hard to see from the street. A chimney can look fine from below and still have a cracked crown, loose bricks at the top, or flashing that has pulled away from the roof. The first sign many homeowners notice is a water stain on a top-floor ceiling or a damp patch on a wall next to the fireplace.

  • Water stains or peeling paint near the chimney breast
  • Crumbling or missing mortar between bricks
  • Spalling brick, where the face flakes or pops off
  • Pieces of tile or masonry falling into the firebox
  • A damper that sticks, will not seal, or has rusted through
  • Smoke or odors coming back into the room

Chimney repairs we handle

We match the repair to the damage. A chimney with a few failed joints needs repointing, not a rebuild. A stack that is loose and leaning above the roofline may need to be partly taken down and relaid. We explain the difference in plain terms before any work starts.

  • Repointing: grinding out failed mortar and replacing it
  • Crown repair or replacement to shed water away from the flue
  • Flashing repair where the chimney meets the roof
  • Chimney caps to keep out rain, debris and animals
  • Partial rebuilds of damaged masonry above the roofline
  • Stainless steel liner installation and relining of damaged flues
  • Damper repair or replacement, including top-sealing dampers
  • Firebox and smoke chamber repair for working fireplaces

Oil-to-gas conversions and new liners

Many Brooklyn Heights buildings have moved, or plan to move, from oil heat to gas. When a New York City building converts its boiler from oil to gas, the chimney has to be evaluated as part of the job. A new liner is often needed. Gas exhaust produces acidic condensate, and over time that condensate can corrode a masonry flue that was built for oil.

We inspect the existing flue and tell you whether it can safely serve the new equipment. If it cannot, we size and install a liner that suits the appliance. We can coordinate timing with your boiler contractor so the chimney work does not hold up the conversion.

Working on rowhouses and pre-war apartment buildings

Chimney work on attached homes takes some planning. Roof access may run through a neighbor's property or a shared bulkhead. A single chimney stack can carry flues for more than one unit. Shared party walls also mean damage on one side can show up on the other. We look at the whole stack, not just your flue, and point out problems that affect the neighboring building.

For apartment buildings and co-ops, we can work with building management or the super to schedule access. Timing also matters. New York City's heat season runs from October 1 through May 31, when owners must keep apartments heated to the city's minimum temperatures. Boiler chimney repairs are easiest to plan outside that window. When a problem comes up during heat season, we focus on getting the heating system venting safely again.

How a repair visit works

Every repair starts with an inspection. The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year, and it describes three levels. A Level 1 inspection fits when nothing about the system has changed. A Level 2 inspection, which includes a camera look inside the flue, applies when the system changes, such as a new appliance or a switch of fuel, or when the home is sold. A Level 3 inspection is used when a hidden hazard can only be reached by opening part of the chimney or the building.

After the inspection, we walk you through what we found, show you photos, and lay out your repair options. We serve Brooklyn Heights along with nearby Downtown Brooklyn, DUMBO, Boerum Hill, Fort Greene and Carroll Gardens.

More services in Brooklyn Heights

Related

What to expect

How a visit goes

  1. We show you what we see

    Camera footage and photos of the flue, crown and firebox let you see the condition of your chimney for yourself instead of taking our word for it.

  2. We recommend only what is needed

    A dirty flue gets a sweep. A cracked crown gets a repair. We explain the difference between what is urgent and what can wait.

  3. We respect your home

    Drop cloths, sealed fireplace openings and HEPA vacuums keep soot and debris contained, and we leave the work area clean.

FAQ

Common questions

How do I know if my Brooklyn Heights chimney needs repair?

Common signs are water stains near the chimney, crumbling mortar, flaking brick, debris in the firebox, a damper that will not close, and smoke coming back into the room. An inspection will show what is causing the problem and how far the damage goes.

Can you repair a chimney on an attached brownstone or rowhouse?

Yes. Much of our work is on attached homes. We plan roof access ahead of time, check whether the stack holds flues for neighboring units, and let you know about any issues that affect the building next door.

Do I need a new liner if my building is switching from oil to gas?

Often, yes. The chimney has to be evaluated as part of an oil-to-gas conversion in New York City. Gas exhaust creates acidic condensate that can corrode a masonry flue, so a new liner is frequently required.

What is the difference between repointing and rebuilding a chimney?

Repointing replaces failed mortar joints while keeping the existing brick. Rebuilding takes down and relays damaged masonry, usually above the roofline. Repointing is enough when the brick is sound. Rebuilding is needed when the stack is loose, leaning or badly spalled.

When is the best time to schedule chimney repair?

Spring through early fall is usually easiest, especially for boiler chimneys, because New York City's heat season runs from October 1 through May 31. If you see signs of a safety problem, have the chimney checked right away no matter the season.

Which neighborhoods near Brooklyn Heights do you serve?

Along with Brooklyn Heights, we serve Downtown Brooklyn, DUMBO, Boerum Hill, Fort Greene, where our office is located, and Carroll Gardens.

Schedule a Chimney or Vent Inspection

Tell us what you are noticing and what kind of building you live in. We will inspect, show you what we find, and give you a written price before any work begins.

Call (912) 881-8281 Request Service