The short answer
EliteFlue repairs chimneys in Park Slope brownstones, rowhouses and pre-war buildings, including repointing, crowns, flashing, caps and flue liners. We inspect first to find the real cause of a problem. We also check flues after oil-to-gas conversions, which often need a new liner.
Most Park Slope chimneys were built long before anyone burned gas in them. Many have spent decades taking freeze-thaw cycles, wind-driven rain and corrosive exhaust. EliteFlue Chimney Services repairs chimneys in brownstones, rowhouses and pre-war apartment buildings across Park Slope (11217), about a mile south of our Fort Greene office. Our certified technicians inspect the whole system first. Then they explain what they found in plain terms and fix what actually needs fixing, from the crown and flashing down to the flue liner and firebox.
Common chimney problems in Park Slope homes
Brownstones and rowhouses in Park Slope usually have masonry chimneys that run along party walls and exit through flat roofs. That layout makes certain problems more likely. Water gets in at the roof line, and mortar joints wear out on the exposed stack. Leaks can also show up a floor or two below where they start.
Many buildings have more than one flue. One usually serves the boiler or water heater, and the others are old fireplace flues that may not have been used in years. Each flue needs to be checked, because an unused one can still let in water, animals or cold air.
- Water stains on walls or ceilings near the chimney, especially after heavy rain
- Crumbling or missing mortar between bricks
- A cracked or eroded chimney crown
- Loose, rusted or lifted flashing where the chimney meets the roof
- Spalling brick, where the faces flake or pop off
- Pieces of tile or masonry falling into the firebox or cleanout
- White staining (efflorescence) on the brick
Chimney repairs we handle
We start with an inspection so the repair matches the actual cause. A leak blamed on the chimney can come from the flashing, from the crown, or from water soaking through porous brick. Fixing the wrong one wastes time and money and leaves the leak in place.
- Repointing: cutting out failed mortar and packing new mortar into the joints
- Rebuilding chimney crowns and sealing crown cracks
- Replacing or resealing flashing at the roof line
- Installing or replacing chimney caps to keep out rain and animals
- Rebuilding damaged brick above the roof line
- Repairing fireboxes, smoke chambers and dampers
- Relining flues with properly sized stainless steel liners
- Applying breathable water repellent to masonry
Oil-to-gas conversions and flue liners
Many Park Slope buildings have already converted their boilers from oil to gas, and others are planning to. In New York City, the chimney has to be evaluated as part of that conversion, and a new liner is often needed. Gas exhaust produces acidic condensate that can corrode an old masonry flue from the inside. That damage usually can't be seen from the roof or the basement.
If your building converted and no one has looked at the flue since, have it checked. We can inspect the flue with a camera and tell you whether the existing liner suits the appliance it serves. If it doesn't, we can install a liner sized for that appliance.
When to schedule chimney repair in Park Slope
New York City's heat season runs from October 1 through May 31. During that time, building owners must keep apartments heated to the city's minimum temperatures. In a multi-unit brownstone or pre-war building, a boiler that can't run because of a blocked or failing flue is a serious problem in January. Late spring and summer are the easiest times for masonry and liner work, before the boiler has to run every day.
The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year. A Level 1 inspection fits when nothing has changed. A Level 2 inspection is the right choice when you've switched fuels, added a new appliance, or are buying or selling a home. A Level 3 inspection means opening part of the chimney or building, and it's only needed when a hidden hazard has to be reached.
Serving Park Slope and nearby neighborhoods
Our Fort Greene office is about a mile north of Park Slope, so homes in 11217 are a short trip for us. We also repair chimneys in Prospect Heights, Carroll Gardens, Cobble Hill, Gowanus and Red Hook. Much of the housing there is similar, with brownstones, rowhouses and older apartment buildings that have the same kinds of chimney problems.
When you reach out, tell us what you're seeing. That might be a stain, falling debris, a smell, or an upcoming conversion or sale. We'll schedule an inspection and explain your repair options clearly before any work starts.
More services in Park Slope
- Chimney Sweep in Park Slope
- Chimney Inspection in Park Slope
- Air Duct Cleaning in Park Slope
- Chimney Liner Installation in Park Slope
